The short version of Karl Fischer titration fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-03-26 and is reviewed periodically as new material appears.
In the body, creatine is synthesized from the amino acids arginine, glycine, and methionine, primarily in the liver and kidneys. It is transported to muscle and other tissues, where it is phosphorylated to phosphocreatine by creatine kinase. This phosphagen system provides a rapid source of adenosine triphosphate during short, intense contractions. Dietary creatine comes mainly from meat and fish, and the body's total pool is influenced by both synthesis and intake.
As a supplement, creatine monohydrate is studied for its effects on muscle performance and recovery. The compound is often described as an ergogenic aid, meaning it may support physical work capacity. Research typically compares it with placebo or other forms, such as citrate or nitrate, under controlled conditions. Questions remain about the optimal dose and long-term effects in different populations, and findings are not uniform across all studies. The monohydrate form remains the most extensively tested.
Solid creatine monohydrate is generally stable when kept dry and protected from extremes of heat and humidity. In the presence of moisture, it can gradually convert to creatinine, a cyclic dehydration product that has little value for phosphocreatine synthesis. Elevated temperatures and acidic conditions accelerate this conversion in solution. Because the reaction is slow in cool, dry storage, typical shelf lives are measured in years rather than weeks. Packaging that limits moisture and oxygen exposure helps maintain purity.
Recommended storage usually involves a sealed container kept at room temperature, away from direct sunlight and moisture. High humidity can cause caking, which changes flow properties and may complicate accurate weighing. Repeated opening of containers exposes the powder to air and moisture, so smaller aliquots can reduce handling effects. Storage temperature ranges are not absolute requirements; they reflect conditions that slow degradation and preserve consistent physical characteristics. Clean, dry tools help prevent contamination during sampling.
Identity and purity are commonly assessed by high-performance liquid chromatography, often with ultraviolet detection, and by spectroscopic techniques such as infrared or nuclear magnetic resonance. These methods can distinguish creatine from creatinine and detect related impurities. Moisture content may be measured by Karl Fischer titration or loss on drying. Particle size, bulk density, and heavy metal limits are additional quality parameters. Not every product is tested by every method, so specifications depend on the intended use and regulatory framework.
| Property | Value | Notes |
|---|---|---|
| Chemical formula | C4H9N3O2·H2O | Monohydrate form; anhydrous is C4H9N3O2 |
| Molar mass | 149.15 g/mol | For the monohydrate |
| Appearance | White crystalline powder | Odorless, slightly bitter taste |
| Solubility in water | ~13 g/L at 25 °C | Poorly soluble; increases with temperature |
| CAS Registry Number | 6020-87-7 | For creatine monohydrate |
Dry creatine monohydrate is generally stable when kept sealed and protected from heat and moisture. In solution, however, creatine undergoes a slow cyclization to creatinine, a related compound with no role in phosphocreatine storage. The rate of this conversion increases with temperature and is influenced by pH. Because creatinine is a common impurity in liquid or poorly stored products, analytical testing often measures both compounds. The crystalline monohydrate is less prone to degradation than aqueous preparations, though caking can occur if moisture enters the container.
Laboratory analysis of creatine monohydrate typically uses high-performance liquid chromatography to separate creatine from creatinine and other impurities. Detection may be ultraviolet, refractive index, or mass spectrometric, depending on the laboratory's equipment and the required sensitivity. Nuclear magnetic resonance spectroscopy can quantify the main component and identify related substances. Water content is measured by Karl Fischer titration, which is important because the monohydrate has a defined theoretical hydration level. Heavy metals, residual solvents, and microbial limits are also checked in quality control programs.
Commercial creatine monohydrate is produced mainly by chemical synthesis rather than extraction from animal tissue. Suppliers provide a certificate of analysis listing assay, water content, and impurity limits, and some products undergo third-party testing. Verification of identity can use infrared or Raman spectroscopy alongside chromatographic methods. Storage recommendations generally call for a cool, dry place and a tightly closed container to limit moisture uptake. Open questions include how packaging, flavoring agents, and long-term storage affect the stability of finished products.
Manufacturing processes can leave trace amounts of dicyandiamide, creatinine, or residual solvents, depending on the synthetic route and purification steps. Heavy metals, arsenic, and microbial contamination are also monitored for food or pharmaceutical grades. Particle size distribution can affect dissolution behavior and blending uniformity, so it may be specified for certain applications. Analytical results are reported on a dry basis or as-is basis, and the difference matters when comparing certificates of analysis. Open questions remain about how minor impurities influence long-term stability under varied storage conditions.
Stability studies typically examine the effects of temperature, humidity, and light on creatine monohydrate. Sealed containers stored in cool, dry conditions help limit moisture uptake and hydrolysis. Elevated temperature and high relative humidity can accelerate conversion to creatinine, especially in aqueous solutions. In solid dosage forms, excipients and processing steps may also affect stability. Published stability data are not fully consistent across studies because test conditions and analytical methods vary.
ACS first established technical divisions in 1908 to foster the exchange of information among scientists who work in particular fields of chemistry or professional interests. Divisional activities include organizing technical sessions at ACS meetings, publishing books and resources, administering awards and lectureships, and conducting other events. The original five divisions were 1) organic chemistry, 2) industrial chemists and chemical engineers, 3) agricultural and food chemistry, 4) fertilizer chemistry, and 5) physical and inorganic chemistry. As of 2016, there are 32 technical divisions of ACS.
Biohazardous safety issues are identified with specified labels, signs and paragraphs established by the American National Standards Institute (ANSI). Today, ANSI Z535 standards for biohazards are used worldwide and should always be used appropriately within ANSI Z535 Hazardous Communications (HazCom) signage, labeling and paragraphs. The goal is to help workers rapidly identify the severity of a biohazard from a distance and through colour and design standardization. Biological hazard symbol design:
Bodybuilding supplements are dietary supplements commonly used by those involved in bodybuilding, weightlifting, mixed martial arts, and athletics for the purpose of facilitating an increase in lean body mass. Bodybuilding supplements may contain ingredients that are advertised to increase a person's muscle, body weight, athletic performance, and decrease a person's percent body fat for desired muscle definition. Among the most widely used are high protein drinks, pre-workout blends and caffeinated energy drinks, branched-chain amino acids (BCAA), glutamine, arginine, essential fatty acids, creatine, HMB, whey protein, ZMA, and weight loss products. Supplements are sold either as single ingredient preparations or in the form of "stacks" – proprietary blends of various supplements marketed as offering synergistic advantages.
Sources: en.wikipedia.org
Risk of developing CJD increases with age. CJD incidence was 3.5 cases per million among those over 50 years of age between 1979 and 2017. Approximately 85% of CJD cases are sporadic, and 10–15% of CJD cases are due to inherited mutations of the prion protein gene. CJD deaths and age-adjusted death rate in the United States indicate an increasing trend in the number of deaths between 1979 and 2017. Although not fully understood, additional information suggests that CJD rates in nonwhite groups are lower than in whites. While the mean onset is approximately 67 years of age, cases of sCJD have been reported as young as 17 years and over 80 years of age. Mental capabilities rapidly deteriorate and the average amount of time from onset of symptoms to death is 7 to 9 months. According to a 2020 systematic review on the international epidemiology of CJD:
An antibody–drug conjugate consists of three components: Antibody - targets the cancer cell surface and may also elicit a therapeutic response. Payload - elicits the desired therapeutic response. Linker - attaches the payload to the antibody and should be stable in circulation only releasing the payload at the desired target. Multiple approaches to conjugation have been developed for attachment to the antibody and reviewed. DAR is the drug to antibody ratio and indicates the level of loading of the payload on the ADC.
Albumin is a family of globular proteins, the most common of which are the serum albumins. All of the proteins of the albumin family are water-soluble, moderately soluble in concentrated salt solutions, and experience heat denaturation. Albumins are commonly found in blood plasma and differ from other blood proteins in that they are not glycosylated. Substances containing albumins are called albuminoids. A number of blood transport proteins are evolutionarily related in the albumin family, including serum albumin, alpha-fetoprotein, vitamin D-binding protein and afamin. This family is only found in vertebrates. Albumins in a less strict sense can mean other proteins that coagulate under certain conditions. See Other albumin types for lactalbumin, ovalbumin and plant "2S albumin". Albumins in general are transport proteins that bind to various ligands and carry them around. Human types include:
Sources: en.wikipedia.org
Asparagine peptide lyase are one of the seven groups in which proteases, also termed proteolytic enzymes, peptidases, or proteinases, are classified according to their catalytic residue. The catalytic mechanism of the asparagine peptide lyases involves an asparagine residue acting as nucleophile to perform a nucleophilic elimination reaction, rather than hydrolysis, to catalyse the breaking of a peptide bond. The existence of this seventh catalytic type of proteases, in which the peptide bond cleavage occurs by self-processing instead of hydrolysis, was demonstrated with the discovery of the crystal structure of the self-cleaving precursor of the Tsh autotransporter from E. coli. These enzymes are synthesized as precursors or propeptides, which cleave themselves by an autoproteolytic reaction. The self-cleaving nature of asparagine peptide lyases contradicts the general definition of an enzyme given that the enzymatic activity destroys the enzyme. However, the self-processing is the action of a proteolytic enzyme, notwithstanding the enzyme is not recoverable from the reaction.
Primary structure Elzinga and co-workers first determined the complete peptide sequence for this type of actin in 1973, with later work by the same author adding further detail to the model. It contains 374 amino acid residues. Its N-terminus is highly acidic and starts with an acetyled aspartate in its amino group, while its C-terminus is alkaline and is formed by a phenylalanine preceded by a cysteine, which has a degree of functional importance. Both extremes are in close proximity within the I-subdomain. An anomalous Nτ-methylhistidine is located at position 73.
Anne-Claude Gingras is a senior investigator at Lunenfeld-Tanenbaum Research Institute, and a professor in the department of molecular genetics at the University of Toronto. She is an expert in mass spectrometry based proteomics technology that allows identification and quantification of protein from various biological samples. Gingras was born on Île d'Orléans, Quebec. She earned her undergraduate degree at Université Laval in Quebec. She completed her PhD in biochemistry at McGill University in Montreal, studying how 4E-BP1 regulated translation initiation, under the mentorship of Nahum Sonenberg. After graduating in 2001, she began postdoctoral research in Seattle at the Institute for Systems Biology in the lab of Ruedi Aebersold, where she studied proteomics for three years. In 2005, Gingras moved to Toronto and joined the Lunenfeld-Tanenbaum Research Institute, and in 2006, she began teaching at the University of Toronto in the department of molecular genetics.
The European Bioinformatics Institute (EMBL-EBI) is an intergovernmental organization (IGO) which, as part of the European Molecular Biology Laboratory (EMBL) family, focuses on research and services in bioinformatics. It is located on the Wellcome Genome Campus in Hinxton near Cambridge, and employs over 600 full-time equivalent (FTE) staff. Further, the EMBL-EBI hosts training programs that teach scientists the fundamentals of the work with biological data and promote the plethora of bioinformatic tools available for their research, both EMBL-EBI-based and not so. One of the roles of the EMBL-EBI is to index and maintain biological data in a set of databases, including Ensembl (housing whole genome sequence data), UniProt (protein sequence and annotation database) and Protein Data Bank (protein and nucleic acid tertiary structure database). A variety of online services and tools is provided, such as Basic Local Alignment Search Tool (BLAST) or Clustal Omega sequence alignment tool, enabling further data analysis.
Sources: en.wikipedia.org
It is a compound made of creatine bound to one water molecule. It appears as a white crystalline powder and is the most common solid form of creatine used in research and supplements.
Creatine is converted to phosphocreatine in muscle, which helps regenerate adenosine triphosphate during brief, high-intensity activity. The body also obtains creatine from foods such as meat and fish.
The creatine molecule is the same whether from food or supplements, but the monohydrate form includes a water molecule in its crystal structure. Once dissolved, the monohydrate and food-derived creatine are chemically identical in the body.
Solid product can remain within specification for years when stored dry and sealed, but expiration dates reflect manufacturer testing and regulatory conventions. Moisture and heat increase conversion to creatinine, so storage conditions matter more than the printed date alone. Degradation is gradual and can be monitored by purity testing.